Automatic Time Setting - Bresser Meteo TP Colour Schnellstartanleitung

All manuals and user guides at all-guides.com
8.
Remote sensor
1.
2.
3.
4.

8 Automatic time setting

After the power supply was established, the clock will auto-
matically search for the radio signal. The clock will automat-
ically search for the radio signal.
If the radio signal is received correctly, the date and time
will be set automatically and the radio control signal icon
turns on.
If the clock fails to receive the time signal, go ahead with the
following steps:
22 / 28
Wait until the indoor temperature is displayed on the
base station.
NOTICE! When switching from mains power supply
to battery power supply or vice versa, the power
supply is being disabled for a short moment for
technical reasons. In this process all settings made
previously, will be deleted.
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Set the channel selector switch to the desired channel.
NOTICE! This weather station can be operated with
one or more remote sensors. Each remote sensor
being connected must be operated on a different
channel. If only one remote sensor is connected, it
should be operated on channel 1.
Replace the battery compartment cover.