Quax COCOON 54F01-0300 Serie Bauanleitung Seite 32

Step 4.7 : Use the construction from step 4.6, the backs 16 and 17, two panel clamps J and twenty-three wood screws I.
Place the two backs (16 and 17) in the cut-outs of the top, bottom and end sides. Check if both angular distances are the
same. Connect both backs at the height of the fi xed shelf using the two panel clamps (J). Push in a wood screw (I) and
tighten in the shelf. Attach the backs to the end sides, bottom and the top with twenty-one wood screws (I).
Step 4.8 : Use the drawer fronts 7, 8 and 9, the pairs of drawer sides 10, 11, 12 and 13, the reinforcement lath 20, seven
connectors F, eight wooden dowels E and six minifi x G.
Tighten the connectors (F) in the holes on the inside of the drawer fronts (7, 8 and 9). Push the wooden dowels (E) into
the drillings at the front of the pairs of drawer sides (10, 11, 12 and 13) and the reinforcement bar (20). Push a minifi x (G)
into the holes on the inside of the sides and the bottom of the bar.
Quax nv Karel Picquélaan 84 B-9800 Deinze Belgium T
COCOON 54F01-0300x
T 0032 9 380 80 95
32
Be careful when installing
the wood screws (I). They
must be securely screwed
into a panel. This requires
some patience, but is neces-
sary for the components to
be mounted at right angles.
www.quax.eu - E E info@quax.eu