Assembly - Beurer Speedbox II Bedienungsanleitung

5

Assembly

Fitting the attachment clip
1. Detach the speed and distance sensor from the attachment
clip by pressing the two front tabs on the clip from above one
after the other.
2. Loosen your shoelace and slide the attachment clip under-
neath.
3. Tie your shoelace in the usual way.
4. Press the speed and distance sensor into the attachment clip.
Note
• The clip must be attached firmly to your shoe in order to
produce accurate measured results.
The device should not make any sideways or tilting
movements while you are running as these will inter-
fere with the results.
• Attach the Speedbox II as far to the front of the shoe as
possible to obtain the most accurate measured results.
25