Safety Feature; Cleaning And Maintenance - EUROM E-convect Bedienungsanleitung

Safety feature

In case of internal overheating, the overheating safeguard will switch the heater off. This may occur if
the heater cannot give off enough heat or if it cannot draw in enough fresh air. As mentioned above, this is
generally caused by (partially) covering the heater, or installing the heater too close to a wall or something
similar. In case of overheating, switch off the heater and unplug. Give the heater time to cool down,
remove the source of the overheating and use as normal. If the problem persists or if you have not been
able to trace the source of the overheating, turn the heater off immediately and unplug. Contact a
servicing point to have the heater repaired.

Cleaning and Maintenance

Keep the heater clean. Switch off the heater, remove the plug from the socket and allow the heater to cool
down before cleaning or carrying out maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive
soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!

You can keep the back of the heater free of dust with a feather duster. For thorough cleaning of the
back, you can unscrew the heater from the wall.

If you want to clean away the E-convect at the end of the season, you can simply unscrew it and
store it, if possible in the original packaging, upright in a cool. Dry and dust-free place.
CE-statement
Euromac bv, Genemuiden-NL hereby declares that the EUROM electrical convector heater, type E-
CONVECT, complies with the LVD guideline 2006/95/EG and the EMC guideline 2004/108/EC and meets
the following standards:
EN 60335-1:2002+A1:2004+A11:2004+A12 :2006
+A2:2006+A13:2008+A14:2010 EN55014-2:1997+A1:2001+A2:2008
EN 60335-2-30:2009
EN 62233 :2008
Genemuiden, 06-06-2012
W.J. Bakker, alg.dir.
EN 55014-1:2006+A1 :2009
EN 61000-3-3 :2008
EN 61000-3-2 :2006+A1 :2009+A2 :2009
14