Drain Hose Kit - Candy CSE H8A1LE-S Anleitung

2. DRAIN HOSE KIT

In order to avoid to empty the water
container after each drying cycle, the water
can be discharged directly to a waste water
drain pipe. Water
connection to a surface water drain. The
waste water drain pipe should be located
adjacent to the tumble dryer.
The kit consists of: 1 hose and 1 bung.
WARNING
Switch off and remove the tumble
dryer plug from the electricity supply
before carrying out any work.
The hose must be connected to a
drain system with a maximum height
of 85 cm compared to the base of the
dryer (figure 1).
Fitting the drain hose
1. The water drainage system is located at
the back of the machine on the lower
right side (figure 2).
2. Disconnect the hose (A) from the fitting
(B) by pulling it upwards (figure 3).
3. Close the extracted tube with the cap
(C) supplied with the kit (figure 4).
4. Connect the hose into the fitting (B)
making sure it is inserted securely
(figures 5-6).
Once the machine is in place, check to
ensure that the new hose does not
kink when pushing the tumble dryer
into position.
Bye-Laws prohibit
1
2
3
4
C
5
6
65
A B