Swim & Fun 2900 Bedienungsanleitung Seite 102

UK
Important
Make sure the square window (for skimmer) is at the top of the steel wall when it is
standing up.
Choose a place where the Skimmer and filtration system will be placed.
Note
The open window for the skimmer should be placed in the direction of the electrical
supply to connect the filtration system.
Insert the steel wall into the bottom rail. For this operation you need to start to insert the end on the
steel wall in correspondence with the center of one bottom metal piece as shown in diagram 7.
Then uncoil the whole wall and insert it into the bottom rail until the circumference is complete as
shown in diagram 8.
When the wall is completely inserted in the bottom rail, connect both ends of the pool wall together.
(See diagram 9). Line up the screw holes and place the bolts through the inside of the pool. Wash-
ers and nuts should be on the outside of the pool wall. (See diagram 10, A: inside, B: Outside)
Once complete, attach and tighten the nuts. (See diagram 11, A: Use the screw to fix head and tail
102
MV-2900-2901-2902-2903-2930-2931-2932-2933-08-2021 . © All rights reserved Swim & Fun A/S