EN
Installation
1. Install left landing gear plate in wing using 4 screws.
2. Install landing gear strut in plate.
4. Install wheel on strut using collar.
5. Tighten setscrew in collar.
6. Install right landing gear the same as left landing gear.
: Refer to other instructions for retractable landing gear installation.
8
All manuals and user guides at all-guides.com
M2.5 X 10
1. Loosen setscrew in collar.
2. Remove collar and wheel from strut.
4. Remove strut from plate.
5. Remove 4 screws and plate from wing.
fuselage using double-sided tape.
without landing gear.
M3 X 20
M3 X 15
Not to scale. Wiring is not
shown. Tape is not shown.
installed in the two rear holes when
holes if using optional retractable
landing gear.