BOMANN GS 176 Bedienungsanleitung, Garantie Seite 21

CAUTION CAUTION CAUTION CAUTION: : : :
In case you disconnect the appliance or in case of power failure:
- Wait for approx. 5 minutes before restarting the appliance.
- Check the operation settings.
• Ensure that your mains power corresponds with the specifications of the appliance. The specifications are
printed on the rating label.
• Connect the mains cable to a properly installed and earthed wall outlet.
Reverse the Door Opening Reverse the Door Opening Reverse the Door Opening Reverse the Door Opening
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appliance must be disconnected from the power supply. Always unplug the
appliance first.
NOTE NOTE: : : : NOTE NOTE
• When installing, ask another person to assist.
You need:
screw wrench, Phillips screwdriver as well as a thin-blade screwdriver.
•
• Unscrew the screws at the appliance back as well as on the top side and remove the appliance cover.
• Dismount the upper door hinge by loosening the screws. Open the
appliance door a little and take it carefully of the lower door hinge.
• Tilt the appliance slightly backwards and block it in this position.
• Unscrew the feet. Dismount the lower door hinge by loosening the screws.
• Attach the lower door hinge at the respective opposite appliance
side, after you have unscrewed the hinge pin and used by the other
hinge side. Turn in the feet accordingly.
• Replace the appliance upright again. Insert the appliance door on the lower hinge pin and fix the door to
the property position.
• Transfer the upper door hinge at the opposite appliance side, after
you have unscrewed the hinge pin and used by the other hinge
side. Put the hinge pin in the hole of the appliance door and tight
the screws of the hinge.
• Replace the appliance cover, which you have removed at the beginning. Tight the screws at the appliance
back as well as on the top side.
• Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the
door is ensured.
• Dismount the door handle and attach it to the corresponding other
door outer side. Refer to the instructions in "Assembling the door
handle". Transfer the cover caps on the exposed holes to the re-
spective other door outer side.
All manuals and user guides at all-guides.com
21