Hantech A020BA-Serie Bedienungsanleitungen Seite 10

2）insert the heat pipe assembly (the end of the exhaust joint) into the back
panel vent slot (push to the left) and complete the assembly (as shown in
figure 1).
1.2 Installation of window sealing plate components
1）Half open the window， and mount the window sealing plate assembly to the
window (as shown in Fig.2 and Fig.3).Components can be placed in horizontal and
vertical direction.
2）Pull various components of the window sealing plate assembly open, adjust
their opening distance to bring both ends of the assembly into contact with the
window frame, and fix various components of the assembly.
1.2 Install the window sealing plate assembly
Notes:1）the flat end of the exhaust pipe joints must be snapped into place.
2)
he pipe cannot be distorted nor has substantial turning (greater than 45 °
). Keep the ventilation of the exhaust pipe not blocked.
Figure 2 Figure 3
1.3
Install the body
1）Move the machine with installed heat pipe and fittings before the window, and the distance
between the body and walls or other objects shall be least 50 cm (as shown in Fig.4).