Installation - Hitachi CP-S860W Bedienungsanleitung

Installation

Typical LCD Projector and Screen Installation
Use the diagram below as reference to determine the screen size and projection distnace.
Top view
Screen
Screen size (inches)
Minimum
40
60
80
100
120
150
200
Using the adjusters
Use the adjusters on the bottom to adjust the projection angle.
Front view
Adjuster
1. Lift up the projector and release the adjuster lock.
2. After adjusting the projection angle, firmly lock the adjusters.
3. Rotate the adjusters for fine adjustment.
Caution
• Do not release the locks unless the projector is being held; otherwise, the projector could
overturn or the fingers could get caught and cause personal injury.
• Do not force the adjusters to rotate. This could damage the adjusters or cause the lock to fail.
• Lock the adjusters firmly. If the lock is difficult to operate, change the angle slightly and try again.
All manuals and user guides at all-guides.com
a
a (inches)
b (inches)
Maximum
55 73
85 114
114 151
144 191
176 231
220 282
291 386
Lens center
b
a. Distance from the LCD projector to the screen
b. Distance from the lens center to the bottom of
the screen (a,b : +/-10%).
1
Caution
2
The LCD projector should normally be used
level (the legs can point upward).
2
Positioning the projector sideways, or with the
3
lens pointing upward or downward can cause the
3
internal temperature to rise, which could result in
a malfunction.
4
The projection distances shown in the diagram to
6
the left are for full size (800 x 600 dots).
Variable within the range of approximately 0° - 9°
Side view
a
Side view