Volume Setting - Samsung SMT-C7200/E Bedienungsanleitung

Press the Standby (
4
When the TV turns off, release the Standby (
TV ( ) button for 3 seconds to confirm the code.
Press the TV (
5

Volume Setting

When a TV ID is programmed the volume control on the remote control regulates the
TV also in device mode. To control the device volume again, press the Exit (
button and Mute (
flash twice to confirm successful volume setting.
For controlling the TV volume once again in device mode, press the TV (
button and Mute (
indicate setup has been successful.
Querying the Stored 4-Digit Code
You can check the 4-digit code stored on the remote control to control your TV set.
- On the remote control, press the 1 (
simultaneously.
The LED will flash as many times as the first number stored.
(No flash means the digit is 0.)
- Press the 2 (
digit.
- Press the 3 (
- Press the 4 (
Resetting the Universal Remote Control
- On the remote control, press the Menü (
and Standby (
flashes twice.
- The remote control deletes all codes stored. Once reset to its default factory
settings, the LED flashes twice again.
14
_ © SAMSUNG ELECTRONICS Co., Ltd.
) button continuously until the TV turns off.
) button to operate your TV.
) button simultaneously for at least 3 seconds. The LED will
) button as described above. The LED will flash twice to
) button and Info (
) button and Info (
) button and Info (
) button simultaneously for at least 3 seconds until the LED
) button and press the
) button and Info (
) button simultaneously for the second
) button simultaneously for the third digit.
) button simultaneously for the last digit.
) button, Teletext (
)
)
) button
) button