Samsung SMT-C7200/E Bedienungsanleitung Seite 111

Antenna Signal
2
The device finds a sufficiently strong and valid antenna signal automatically.
- If the device does not find a valid signal an error message will be displayed, asking
you to re-try the signal check or check the cable layout.
New Software
3
The device will check for a software update.
- You are not given the choice to reject the upgrade if one is found.
- If a software update is detected, the device will reboot after a countdown from
5 seconds and begins with the software update.
- If no new software version is detected, the Installation Wizard will proceed to the next
screen.
Do not power off the STB while updating a software.
Smartcard
4
The device checks whether a valid Smartcard is inserted.
Before this check please open the flap and insert the Smartcard into the
Smartcard slot.
- If an error is detected, the appropriate Smartcard error message will be displayed.
- Insert the Smartcard with the chip facing down or press the Zurück (
to use the device without a Smartcard. When using the STB without the Smartcard,
you will be able to view uncoded channels only.
- You can press the Opt (
control. Please refer to the "Language Selection" on page 28.
) button to configure language selection on the remote
) button
27
English _