Imetec R7506 Bedienungsanleitung Seite 20

This chapter describes the most common problems that can arise using the
EN
appliance. If the problems cannot be solved with the information below, please
contact the Authorised Service Centre.
Problem
The LEDs on the control unit
do not light up.
The blue warning light is
flashing.
Temperature LED 1 (11) is
flashing.
The product has been used
incorrectly or is damaged.
The power cable or another
internal wire is damaged.
The control unit is damaged.
There are holes or tears in the
fabric or stubborn creases that
do not spread out.
The packaging of the appliance is made of recyclable materials. Dispose of the packaging in
accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), the
19
TROUBLESHOOTING
Check that the control unit plug is fully inserted in
the socket (3). If the LEDs remain off, remove the
control unit plug from the socket (3) and return the
throw to an authorised technical service centre.
Turn the control unit off and remove the plug from
the socket (3). Check that the control unit connector
(2) is fully inserted in the throw connector (1) and
reinsert the plug in the socket (3). If the standby LED
continues to flash, return the throw to an authorised
technical service centre.
Return the throw to an authorised technical service
centre to be checked.
DISPOSAL
Solution