Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cooking vessels (Fig. 3)
- a magnet-attracting vessel may be a suitable vessel for induction
cook-ing
- prefer vessels which are especially declared to be suitable for
induc-tion cooking
- flat and thick bottomed vessels
- a vessel with the same diameter as zones ensures the maximum
exploitation of power
- a smaller vessel reduces power exploitation, but does not cause
any energy loss. We would anyhow not recommend the use of
vessels with diameters smaller than 12 cm.
- stainless-steel vessels with multi-layer or ferritic stainless-steel
bottoms when specifically suited for induction cooking
- cast-iron preferably enamel-bottomed vessels to avoid scratching
the pyroceram surface
- we do not recommend the use of any glass, ceramic, earthenware
alluminium, copper or non-magnetic (austenitic) stainless steel
vessels.
Maintenance (Fig. 4)
By means of a scraper immediately remove any aluminum foil bits,
food spills, grease splashes, sugar marks and other high sugar
content food from the surface in order to avoid damaging the hob.
Subsequently clean the surface with some towel and appropriate
product, rinse with water and dry by means of a clean cloth. Under
no circum-stance should sponges or abrasive cloths be used; also
avoid using aggressive chemical detergents such as oven sprays and
spot removers.
Installer's Instructions
Installation
These Instructions are for the qualified technician, as a guide to
installa-tion, adjustment and maintenance, according to the laws
and standards in force. These operations must always be carried out
when the appliance has been disconnected from the electric system.
Positioning (Fig. 5)
The fixture is especially designed for fitting into a work-top as shown
in the corresponding figure.
Place the supplied sealing agent along the hob perimeter.
Do not install the hob over an oven; in case you do, make sure of
the following:
- the oven is equipped with an appropriate cooling system
- there is no warm-air leakage from the oven towards the hob -
suitable air-inlets are provided as shown in the figure.
Electrical connection (Fig. 6)
Prior to carrying out the electrical connection, please ensure that:
- the plant characteristics are such as to follow what is indicated on
the matrix plate placed at the bottom of the working area;
- that the plant is fitted with an efficient earth connection, following
the standards and law provisions in force.
The earth connection is compulsory in terms of the law.
Should there be no cable and/or plug on the equipment, use suitable
absorption material for the working temperature as well, as indicated
on the matrix plate. Under no circumstance must the cable reach a
tempera-ture above 50°C of the ambient temperature.
Werbung
