Operating Noises - Pevino PNG20S-HHB Bedienungsanleitung

DOOR OPENING ANGLE AND DIMENSIONS
PNG20S-HHB
TURNING ON YOUR WINE COOLER
Plug in and switch on the unit by pressing the power button for a few seconds.
When you use the wine cooler for the first time (or restart the wine cooler after having it shut off for a long
period), there will be a few degrees variance between the temperature you have selected and the one indicated
on the LED display. This is normal and it is due to the length of the activation time. Once the wine cooler is
running for a few hours everything will stabilize.
Important: If the unit is unplugged, power is lost, or turned off, wait 3 to 5 minutes before restarting the
unit. The wine cooler will not start if you attempt to restart before this time delay.

OPERATING NOISES

The noise level is very low. Both the compressor and the fan has a very low noise level during normal operation.
The compressor can run at different speeds. This saves energy. Higher compressor speed is used to increase the
cooling capacity, for example at initial switch on, the thermostat's set point is lowered, or if the door has been
open. When the correct temperature is reached or wine bottles are cooled the compressor will again run at
reduced speed and have a very low noise level. During start-up, the compressor will always run with maximum
speed. This provides a higher level of noise until the set temperature has been reached.
6