Herunterladen Inhalt Inhalt Diese Seite drucken

Dane Techniczne; Cleaning And Maintenance; Troubleshooting - Stalgast GN 1/1 Bedienungsanleitung

Elektro-chafing dish
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2.1. Description of the device

3. DANE TECHNICZNE

Power input
Total generated power
Dimensions
Capacity
4. ASSEMBLY
4.1. Connecting to the source of electricity
The device should be plugged into a 230V socket. The socket must be grounded.
5. OPERATING THE DEVICE
• Fill the tank with the correct amount of water.
• Do not initiate the device when the tank is empty.
• Use the temperature control knob to set the correct temperature. (range is 0 to 85 °C).
Attention: remember to maintain a proper amount of water in the tank! Check the water level regularly, also when the device
is in use.

6. CLEANING AND MAINTENANCE

• Always unplug the device before cleaning it.
• In case of heavy use remember to clean limescale sediment from the bottom of water tank.
• Never submerge the device into water or any other cleaning detergent.
• Clean the device with a damp cloth.
• Do not use abrasive or corrosive cleaning detergents to clean the device.
• Make sure none of the electrical elements of the device ever come in contact with water.

7. TROUBLESHOOTING

FAULT
The device does not work
The device does not heat up to
the desired temperature
8. DISPOSAL OF THE OLD APPLIANCE
Information for users on the rules concerning proper disposal of electrical and electronic equipment at the end of its life.
• Leave your old equipment in the shop where you purchase a new appliance. Each store is obliged to accept old equipment
free of charge if you buy there the new equipment of the same type and in the same quantity. The only condition is to deliver
the old equipment to the store at your expense.
• Dispose of your old equipment at a collection point. Information about the location of the nearest collection point can be
found on the local website or the notice board of the municipal office.
Indicator light
Temperature control knop
Power switch
230 V / 50 Hz
2 kW
620x480x300 mm
13 l
POSSIBLE CAUSE
No power in the socket
The socket is plugged in incorrectly
Heating element damaged
Control unit damaged
Heating element fuse damaged
- 9 -
Socket
PROPOSED SOLUTION
Check the fuse
Check the plug
Contact the seller
Contact the seller
Contact the seller

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

435130

Inhaltsverzeichnis