Remington Renew IPL2500 Bedienungsanleitung Seite 12

ENGLISH
• Press the flash button to deliver a flash. Fig. 13.
, Tip: It is helpful to use a mirror to see the Skin Tone Tester. If the reflected light is unpleasant, you may
wish to close your eyes before each flash.
• Mild to moderate discomfort is normal.
• If a flash delivered at Energy Level 1 feels tolerable and there are no adverse reactions, wait a few
minutes and increase to Energy Level 2.
• Move the device to a different spot and flash the RENEW one more time.
• Repeat this process until you find the setting that feels right for you.
, WARNING: do not flash the same spot more than once; you will not get an accurate result and it may
cause side effects.
• Wait 24 hours and then look at the test area. If the skin appears normal, proceed with your first full
treatment at the energy level you determined is right for you.
, NOTE: You must test the device on each area of the face you wish to treat.
, WARNING: If you notice bleeding, blistering, burns, changes in your base skin tone or any adverse
reactions from the Skin Patch Test at the lowest energy level, or if you are not sure about the outcome
of the test DO NOT USE the device.
• If you have followed the instructions in this section and continue to experience problems please visit
www.remington-europe.com/IPL2500 or contact your local Remington® Service Centre for further
assistance.
, Treat your Skin with the RENEW Skin Rejuvenation Device
, Prepare your skin for treatment
• Ensure the area to be treated is clean and free from oils, deodorants, perfume, make up, lotions and
creams. Shave or trim any dark hair from the area to be treated and ensure the skin is clean and dry.
Fig. 14.
If trimming; the hair must be trimmed to less than 0.5mm.
12
Fig. 13
Fig. 14