Sunny SF-E3903 Benutzerhandbuch Seite 18

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-
907-8669).
STEP 2:
Remove Screw (No. 55) and Curve Washer
(No. 56) from the Tension Control Knob (No.
54) using Spanner (No. C).
Insert Tension Control Wire (No. 54a) into
Handlebar Post (No. 42) and pull it out from
the bottom.
Attach the Tension Control Knob (No. 54) to
Handlebar Post (No. 42) using 1 Screw (No.
55) and 1 Curved Washer (No. 56) that were
removed. Tighten and secure with Spanner
(No. C).
Note: Please make sure the Tension Control
Knob (No. 54) is at the lowest resistance level
(level 1, all the way to the left) before you
connect the Tension Control Wire (No. 54a).
Connect the Trunk Wire (No. 53) with the link
wire of Sensor (No. 109) and connect Tension
Control Wire (No. 54a) with Tension Wire
(No. 60). Then, insert Tension Control Wire
(No. 54a) into the slot on metal bracket of
Tension Wire (No. 60). Make sure the metal
fitting on Tension Control Wire (No. 54a) is
secured into the metal bracket.
Attach Handlebar Post (No. 42) to the Main
Frame (No. 59) using 3 Bolts (No. 41), 2 Bolts
(No. 40), 3 Spring Washers (No. 30), 2 Nylon
Nuts (No. 23) and 7 Curved Washers (No.
34). Tighten and secure with Allen Wrench
(No. A) and Spanner (No. C)
17