Technics SU-G700M2 Bedienungsanleitung Seite 18

Operations
Using this unit as power amplifier
You can connect the AV receiver, control amplifier, etc. with
analogue audio cable (not supplied) to this unit and use this unit
as power amplifier.
Set the volume of the AV receiver,
control amplifier, etc. to minimum before
connecting.
While using this unit as power amplifier,
the volume adjustment with this unit is
disabled. Adjust the volume little by little
with the connected device.
Do not input the audio signal from PRE
OUT/LINE OUT terminals to the MAIN IN
terminals of this unit. Doing so may cause
malfunction.
18
(18)
AV receiver, control
amplifier, etc.
Analogue audio cable
(not supplied)
Using analogue audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and AV receiver,
control amplifier, etc. after minimising
the volume of the device.
3 Connect the AC mains lead to this
unit. ( 13)
4 Press [AMP ] to turn this unit on.
5 Press [>INPUT<] repeatedly to select
"LINE2".
• You can also select the input source by
turning the input selector knob on the unit.
6 Press [AMP].
7 Press [MENU].
8 Press [ ], [ ] repeatedly to select
"Input Mode" and then press [OK].
9 Press [ ], [ ] to select "MAIN IN" and
press [OK].