Speaker Connection - Technics SU-G700M2 Bedienungsanleitung

Connections
Speakers/AC mains lead
• Use only the supplied AC mains lead.
• Insert the plugs of the cables to be connected all the way in.
• Do not bend cables at sharp angles.
• This unit can measure the output signal of the amplifier and correct its output to make the
optimum adjustment of speaker output. ( 24)
• To optimise the audio output from the speakers, you can measure the amplifier output
signal and correct its output when it is connected to the speakers. ( 24)

Speaker connection

1 Turn the knobs to
loosen them, and
insert the core wires
into the holes.
2 Tighten the knobs.
Note
• When the connections are completed, pull the
speaker cables lightly to check that they are
connected firmly.
• Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so
may damage the amplifier.
12
(12)
Speaker cable (not supplied)
• Wire the polarity (+/-) of the terminals correctly.
Not doing so may adversely affect stereo
effects or cause malfunction.
• For details, refer to the operating instructions of
the speakers.
• Though the spade plug (A: 16 mm or less, B:
8 mm or more) can be connected, some plug
may not be connected depending on the shape
of plug.
DO NOT
A B