Eufab 16408 Montageanleitung Seite 4

Part no. 16408
Bicycle wall bracket
Assembly instructions
- Connect both wheel rails (item 8) with the vertical rail (item 5)
- Fasten the rails in the front and rear drill holes using the M 5 x 8 bolts (item 11) and the
M 5 nuts (item 12)
- Wall attachment with M 5 x 12 countersunk bolts (item 10) and M 5 nuts (item 12)
- When attaching the wall bracket, make sure the wheel rails are fastened level
Caution:
Watch out for hidden cable lines while drilling. Do not damage or drill into structural parts.
Insert the dowel (item 7) into the drill holes (4 x 30 Phillips cross head screw (item 6)
-
Put the adjustment slide (item 2) into the vertical rail from the top
-
- The elongated hole for the safety bolts (item 4) must be located on the right-hand side
The safety bolts must lead through both of the vertical rail plate-cheeks
-
Push the safety bolt down – the adjustment slides are secured
-
- Guide the bicycle frame bracket (item 1) into the adjustment slides
Secure the frame with the retaining pin (item 3)
-
- Turn the frame bracket right side up
- Put on the bicycle – the pedal toward the wall must face upwards
- Lay the bicycle frame bracket over the frame – the bicycle is secured
Parts list:
Item 1 Bicycle frame bracket
Item 2 Adjustment slides
Item 3 3 Ø mm retaining pin
Item 4 Safety bolts
Item 5 Bicycle rails
Item 6 Phillips cross head screw 4 x 30
Item 7 Dowel
Item 8 Wheel rails
Item 9 Countersunk bolts M 5 x 12
Item 10 Screws M 5 x 8
Item 11 Nuts M 5
Hex hey
Thank you for having decided in favour of a Eufab product!
All manuals and user guides at all-guides.com
1x
1x
1x
1x
1x
6x
6x
2x
2x
4x
6x
4