Pevino PNG46S Bedienungsanleitung Seite 17

Warning: To avoid accidents during the process of changing the door, we recommend that you get assistance.
The glass door is heavy and may cause injury if dropped.
1. To put the cabinet on open operation place, the door opened to the maximum angle
2. Use small knife(2) to take off the decorative nail (1) on opposite side (Drawing 1);
3. Use the inner six angle screwdriver (Tool 5) to disassemble the screws(4) of drop-proof device (3), then
remove the drop-proof device .(Drawing 1)
4. Hold the door, use six angle screwdriver (Tool 5) to screw out the door shaft core(6) from the two ends
of the top of the door. Take out the door and set aside. (Drawing 2)
5. Discharge the upper and lower door hinge(7)(8) by M5 inner six angle screwdriver (Tool 5) , then to
assemble the door hinge on the opposite side. (Drawing 3 and 4 )
6. Remove the decorative cover(9)(10) and Plastic gasket of drop-roof device (11)on the left side of the
door and install it on the right side of the door., then Install the door on the left side of the cabinet.
(Drawing 5)
7. Finally, install the decorative nail and drop-proof device at the opposite side. (Drawing 6)
REVERSIBILITY OF THE DOOR
17