Creality CR-10 Smart Benutzerhandbuch Seite 16

Notes: The print preheating standard is adjusted at the factory, PLA preheating
standard: nozzle temperature 200 °, hot bed temperature 60 °, ABS preheating
standard: nozzle temperature 240 °, hot bed temperature 70 °. If you need to adjust it
due to printing materials or other reasons, you can adjust the parameters on the
interface home page control → temperature → PLA / ABS preheat setting.
Load Filament
When you wait for the temperature to rise, hang the filament over the Filament Holder.