air&me ROHAN Bedienungsanleitung Seite 23

EMPTYING THE TANK (SEE PAGE 3)
The appliance automatically stops working once the tank is full. The appliance rings 10 times and
the [ Full tank ] indicator (
Turn the appliance off and pull the tank thanks to the side handles.
1
Unclip the handle and remove the water tank lid.
2
Empty the condensates.
3
Replace the lid and the tank. Then, press the ON/OFF button and choose the desired operating
4
mode.
The dehumidifier is equipped with a tank positioning sensor. As a matter of security, the product
turns off after few minutes if the tank is missing or not properly placed.
CONTINUOUS DRAINAGE (SEE PAGE 3)
Thanks to the continuous drainage hose, the appliance will work independently without having
to manually empty the tank.
Turn the appliance off, unscrew and remove the plastic plug from the hole for the continuous
1
drainage hose.
Connect the continuous drainage hose (60 cm and ø 13 mm) on the back of the dehumidifier.
2
To avoid leaks, make sure the hose is not bent and that it is placed on a downward slope so
that water can easily drain away. Do not modify or extend the drainage hose.
Turn the appliance on.
3
LIFT PUMP CONNECTION (SEE PAGE 3)
Thanks to the build-in lift pump, the appliance will work independently, without having to
manually empty the tank and will be able to discharge condensates upward.
Turn the appliance off and then remove the rubber plug from the hole for the lift pump hose.
1
Connect the lift pump hose (3 m and ø 5 mm) on the back of the dehumidifier. To avoid leaks,
2
make sure the hose is not bent. Do not modify or extend the lift pump hose. The lift pump hose
must not exceed 5 m.
Turn the appliance on. You can now activate the [ Lift pump ] function (
3
panel.
) lights.
E
) on the control
H
23