Malfunction Possible Cause Solution - Fakir HYPO GUARD Benutzerhandbuch

EN

Malfunction Possible Cause Solution

Your appliance is processed via Quality Control against any malfunction.
However if it is not operational due to any reason, ensure that you have tried the solutions
specified in the table below before contacting Fakir Authorized Service.
Malfunction
LED is not lit.
The LED is on
but bubbling.
It slightly bubbles.
In the middle of
the operation,
the LED of the
start button is
continuously
flashing with a
beep sound.
After the extra
hygienic water
generation process
is completed, the
appliance does not
operate by pressing
the Start Button.
Even after the
process is
complete, the
LED is still on.
Possible Cause
The adapter (and the plug) may not be
connected properly.
Spray Bottle may not be properly
installed in the body.
Pure water or mineral water might have
been used instead of tap water.
Less than 1 litre of water and 2 g salt
may have been added.
After the previous process, 1 minute of
waiting time may not be over.
It is normal for the LED light on the
bottom of the Spray Bottle and the LED
for the Start Button to continue to light
up to let you know that the process
is over after the water production is
complete.
Solution
Make sure that you have
properly connected the
adapter and the outlet.
Place the Sprayer Bottle
properly in the Body and
check that the appliance is
working.
Use only tap water. Also,
more bubbles occur when
salt is added compared to
when only tap water is used.
If the amount of water is
insufficient and too much
salt is added, the appliance
will not operate for safety
reasons. Run the appliance
once more after adding
recommended amount of
salt.
It is normal for the appliance
not to operate for 1 minute
after electrolysed water is
produced.
Remove the Spray Bottle
from the Body to turn off
the LED light in the bottle.
However, this does not allow
the LED light in the Body to
turn off.
36