Standby Mode; Operating Mode; Completion Mode - Fakir HYPO GUARD Benutzerhandbuch

Standby Mode

If you want to stop the appliance in the middle of the water production process, the appliance
goes into Sleep Mode when you press and hold the Start Button for 5 seconds.
WARNING!
Do not remove the pitcher from the housing during operation. Otherwise, this may damage
the appliance.

Completion Mode

NOTE!
If you want to restart the device, start it 3 minutes after the previous operation.
When the device is connected to power as shown in Figure 4, all
LED lights on the start button will be on in standby mode. Press
the start button for 1 second to start the operation.
Note: If you remove the pitcher from the main body in standby
mode, the device goes directly to sleep mode.

Operating Mode

Press the start button for 1 second when the device is in standby
mode. The operation mode will be activated with a beep sound. In this
mode, the LED lights on the start button will flash as shown in Figure
5. Within 3 seconds, the blue light inside the pitcher turns on and the
operation starts with the melody. Operation time is 5 minutes.
When the operation is completed, the LED lights on the start
button turn up as shown in figure 6 and your device goes the
completion mode with the melody.
3 minutes after the operation is completed, the lights in the pitcher
and the start button will turn off and the device will automatically
turn off.
33
EN