Sleep Mode; Warning Mode; Cleaning And Maintenance Of The Appliance - Fakir HYPO GUARD Benutzerhandbuch

EN

Sleep Mode

appliance to return to Standby Mode, place the pitcher back on the Housing and press the
button for 1 second.

Warning Mode

Cleaning and Maintenance of the Appliance

Do not leave water in the pitcher and the spray bottle for a long time. If it is not to be used for
a long time, store the appliance (with the pitcher, cover of the pitcher, spray bottle and spray
nozzle, etc.) in a completely dry place, free from moisture or direct sunlight. If the appliance
is stored at very low temperatures, the efficiency may be reduced and the appliance may
fail due to water frost. Storing at very low temperatures can cause the performance of the
appliance to drop and the water in the container to freeze.
Use a dry, clean cloth when cleaning the outside of the appliance. Do not use chemicals or
detergents. The part between the pitcher and the housing should not come into contact with
the water. In case of contact with water, wipe off the water and dry thoroughly.
Do not clean the electrodes under the pitcher or apply excessive force to them when wiping.
If you see residues in the pitcher, clean it carefully so as not to damage the electrodes. Then
run the appliance for 3 minutes with salt added. Allow the pitcher to stay in the prepared water
for one hour and rinse with clean tap water for next use. Do not use the appliance for 1 hour.
Clean the surface if you see white residues on the electrodes after using the appliance for a
long time. Pour
1) 200 ml of warm water and 20 g of citric acid (sold separately) or
2) 100 ml water and 100 ml vinegar into the bottle and leave it for another hour so that the
electrodes are cleaned.
Then empty and wash the bottle.
This way, wash it every 2 or 3 months.
While the device is in sleep mode as shown in the figure, no LED
lights are on, this mode is called the Power Saving Mode. If you
want to return to standby mode, press the start button for 1 second.
When the Completion Mode ends, the appliance goes into the
Sleep Mode automatically with a beep sound. If you want the
All LED lights flash, as shown in the Figure 8.
If the water in the pitcher is not enough or there is too much salt in
the water, all the LED lights will flash after a beep (3 consecutive
beeps). If you want to stop the warning sound, press and hold the
Start Button for 5 seconds or remove the pitcher from the housing.
If the button is not pressed, the warning sound keeps for 3 minutes
and then the appliance goes into the Standby Mode.
34