IMPORTANT NOTES This guide is an aid for the professional installation of the device. Please note the following notes before installation: • Always handle all parts of the device and the components of your vehicle with care. • Under all circumstances observe the regulations of the vehicle manufacturer and do not make any changes to the vehicle which could impair driving safety.
Lay the supplied cable sets and antennas in the vehicle. Please note the information on the next page. Then connect all cable sets, antennas and dongles to the ESX main device as described on page 6. Then plug in the cable plug from the radio slot of the vehicle on the ESX main unit or on its vehicle-specific system cable set.
SCOPE OF DELIVERY ITEM FIGURE QUANTITY Main device ISO system cable set (20-pin connector) AV cable set 1 with audio and video connections incl. rear view camera (14-pin connector) USB port 1 (4-pin connector) 4G/LTE dongle (6-pin connector) USB port 2 (8-pin connector) Camera cable set for HD rear view camera...
Seite 5
SCOPE OF DELIVERY ITEM FIGURE QUANTITY AV cable set 2 with power, audio and video connections, additional camera input (8-pin connector) External microphone (6-pin connector) GPS antenna DAB antenna 4G/LTE antenna VNA-LFB-FD6 Adapter for analog steering wheel remote control (Only VNC940-DBJ-4G and VNC945-DBJ-4G)
WIRING DIAGRAM GPS antenna WiFi antenna Fuse 10A DAB antenna 4G/LTE antenna 20-pin system socket Inputs for AV cable sets Radio antenna (F can be assigned for later accessories) Assignment system socket System cable set 1 (20-pin connector, black) Cable brown (BRAKE): Connection for handbrake signal (ground) Cable pink (BACK): Connection for reverse gear signal (+ 12V)
Seite 7
WIRING DIAGRAM Assignment of AV connections AV cable set 1 (14-pin connector, black) RCA white (FL): Audio output Front/Left RCA red (FR): Audio output Front/Right RCA white (RL): Audio output Rear/Left RCA red (RR): Audio output Rear/Right RCA green (SUB WOOFER): Audio output Subwoofer RCA yellow (VIDEO OUT 1): Video output for external monitor 1...
Kleben Sie das Erdungsblatt der Verstärkereinheit auf den Metallteil auf der Frontsäule. GENERAL INSTALLATION INSTRUCTIONS Reinigen Sie die Windschutzscheibe mit auübersicht einem geigneten Reinigungstuch. enne sollte aus Sicherheitsgründen auf der Beifahrerseite GPS antenna rt werden. The GPS antenna must be glued horizontally to the front of the dash- Remove the film on the underside of the board.
Seite 9
SETUP THE 4G/LTE INTERNET CONNECTION First lay the two 4G/LTE antennas inside the dashboard towards the windshield, one antenna for the left and one for the right. Ideally, you should stick the antennas to the windshield to ensure optimal recep- tion.
Seite 10
SETUP THE 4G/LTE INTERNET CONNECTION Then turn on the device to test the 4G/LTE connection. After the device has started, enter After successful entry, the SIM card is your 4-digit PIN code of the SIM card unlocked. here. Confirm the entry with the tick. If the device is successfully connect- If the device is turned off, you have ed to the mobile Internet, the „LTE“...
Seite 11
TECHNICAL DATA / RADIO SYSTEM TYPE Function Band Information Frequency Range Max. emitted power GLONASS 1.575MHz / 1.602 MHz – AM Radio Medium wave 520 - 1.700 Hz – FM Radio Band II 87,5 - 108 MHz – DAB Radio Band III (5A –...