Klarfit Rocketkid Bedienungsanleitung Seite 20

EN
20
• Take one of the bungee cords (k, hereafter: 'springs'), pull it through a tab
of the jump mat and form a loop through which you pull the pin end (see
illustrations above and below).
• Repeat this procedure for all 30 tabs and check the hold by applying
pressure to the mat (with your hand) without standing on it. Do not stand
on the trampoline until you have checked the connections.
Tip: It is best to proceed in the manner shown here - connect opposite tabs
to the frame in each case. This ensures that you do not skip any flaps and
that the tension is built up evenly.
• Place the protective mat over the frame and springs, making sure that
the indentations in the mat are resting against the respective protruding
connecting tubes of the frame.
• Carefully pull down the safety net, which is connected to the protective
mat, on all sides of the trampoline.
• There is a hole on each stand for attaching the safety net to the stand with
a screw. Use a screw and attach the safety net to each stand. Be careful
not to overtighten the thread.