Getting Started - DNT RFK Integro 3.5 Bedienungsanleitung

Getting started

Please check the functionality of the components before installing.
Installing of the camera
You may need a voltage meter to check the polarity of the reversing light.
clasps
Cut off the surplus plastic.
Remove the power supply connection wire from the car battery. Place the removed connec-
tion wire far away from the electrode. So it cannot be connected by misstake or accident.
Use a pair of cutting nippers to cut two clasps on the frame of camera license plate, and trim
away the surplus plastic at the bayonet.
Install the camera license plate at the location of license plate. The product can be directly
clipped on the corresponding type of car. If the car does not belong to the corresponding type,
you can drill holes and use lock screws to fasten the product.
Insert the power cable of camera in the car through the gap of the license plate lamp (or drill
a hole and embed the power cable inside the bumper guard).
Connect the power cable of camera to the wireless transmitting box.
Cut off the two clasps and trim
away the surplus plastic of the clasp
- 14 -