Start Printing - ATOMSTACK Cambrian Bedienungsanleitung

a:Select the printing file
Power on, insert the TF card into the
motherboard card slot at the front of the
device. Click the "Print" button to enter the
file list, select a print file and click to enter
the print information confirmation page

12.Start printing

b:Confirm the printer parameter
Before starting to print, you need to
confirm the printing information. After
confirming that it is correct, click the "Start"
button to start printing
c:Heat the heating bed
After starting to print, the device will first
heat the heating bed (heated to the
temperature set during slicing). The hot bed
heating is to make the bottom of the model
better bond with the heating bed.
d:Heat the nozzle
When the heating bed is heated to the
target temperature, the equipment will
start heating the nozzle. When the nozzle is
heated to the target temperature, the
printer will start printing. This process is
estimated to take a few minutes.