Material Preparation; Prepare To Load The Material - ATOMSTACK Cambrian Bedienungsanleitung

11.1 Prepare to load the material

• Before you start printing, you need to prepare the required printing materials. The printing material should be the same as the material selected in the software when
slicing, prevent the printing failure or unsatisfactory printing effect.
• When using the E285 print extruder to print, it is necessary to estimate the amount of required material for the model. Cambrian has an automatic detection function.
Once there is no material, the device will automatically stop printing. In this case, the residual material left in the print extruder needs to be removed with a suitable tool.
And then add new materials, printer can realize the function of interrupted material and continuous printing. However, it is still recommended to reserve enough amount
of material before printing. The amount of material can be calculated in the Cura software as a reference.
• Once there is a shortage of materials when using the E175 print extruder to print. It is also necessary to remove the residual material left in the print extruder with a
suitable tool. And then add new materials, but you need to start printing from the beginning. Currently is not available for the interrupted printing.
• If the device is turned off due to unexpected circumstances during the printing process, you can continue to print unfinished works after turning on the machine, and
support the function of printing after power failure

11.Material preparation