ATOMSTACK Cambrian Bedienungsanleitung Seite 16

5. On the "Printer" options page, delete the codes in Start G-
code and End G-code respectively, and then find the "CUSTOM"
package from the data package of the gift TF card and open it in
sequence 1. "Custom Files "> 2. "Cura config file"> 3. "Printer
Start&End Gcode" is opened, and then copy the Start G-code
and End G-code codes to the code are shown in the figure
(E285 and E175 printers need to be copied and added Start G-
code and End G-code code)
6. Under the "Extruder1" tab, set the nozzle parameters
according to the currently installed nozzle specifications. The
above picture shows the parameter configuration of the nozzle
for printing E285 material. Nozzle aperture: 0.8mm, compatible
material diameter: 2.85mm (E175 material printer nozzle
Aperture: 0.4mm, compatible material diameter: 1.75mm)