Cleaning, Care & Maintenance - Polar UA001 Bedienungsanleitung

Adjusting the Temperature
1. Press for 3 seconds. The set temperature
on the display will flash.
2. Press or to change the set
temperature.
3. Wait 6 seconds for the set temperature to be
stored.
Manual Defrost
Automatic defrost:
The appliance features an
automatic defrost. However,
should the appliance require an
additional defrost period, carry
out below operations:
1. Press for 3 seconds to enter defrosting
mode. The symbol
display.
2. Press for 3 seconds again to exit.
Short cut operations for
refrigerators only:
1. Press once to enter fish mode and display
the set temperature (Range: -1°C ~ 1°C).
2. Press once to enter meat mode and display
the set temperature (Range: -2°C ~ 2°C).
3. Press once to return to general mode and
display the set temperature (Range: 1°C ~
4°C).
UA001-UA002-UA003-UA004_ML_A5_v2_20211111.indb 7 UA001-UA002-UA003-UA004_ML_A5_v2_20211111.indb 7
Cleaning, Care &
Maintenance
•
•
•
•
will appear on the
Cleaning the condenser
•
•
•
1. The condenser is located above the refrigerator
2. These models have a removable filter which
Switch off and disconnect
from the power supply before
cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Clean the door seals with warm soapy water.
Always wipe dry after cleaning.
Note: Condensation will form in
refrigeration on hot humid days,
please ensure condensation is
allowed to drain properly or is
wiped dry.
The condenser is part of the
refrigeration system. The condenser
requires monthly cleaning.
Always disconnect power supply before
carrying out routine maintenance.
Failure to clean the condenser will
reduce the performance and life of your
unit and may invalidate your warranty.
cabinet at the top.
can be taken out directly. Clean with a vacuum
cleaner.
UK
7
2021/11/15 10:19 2021/11/15 10:19