Cleaning, Care & Maintenance - Polar DM075 Bedienungsanleitung

EN
Operation
Control Panel
The control panel is located below the doors on the
front of the appliance.
To unlock / Lock the keyboard press
together for 3 seconds. Display will flash PON
(unlocked) / POF (locked).
Turn On
1. Close the door of the appliance.
2. Connect the appliance to a mains power
supply.
3. Turn the light switches On [I] or Off [O] as
desired.
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Do not place uncovered items as below inside
the appliance, as this can lead to a damaged
and leaking evaporator, and thus void your
warranty: hot food, hot liquids, acidic fluids,
acidic products.
• Wrap or cover food where possible.
6
DM075-DM076_GH426-GH427_ML_A5_v9_20221125.indb 6 DM075-DM076_GH426-GH427_ML_A5_v9_20221125.indb 6
and
buttons to display the
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods
of time.
Lock/Unlock the Doors
• A lock is fitted to the door to ensure foodstuffs
are kept secure within your POLAR appliance.
• Use the keys provided to lock/unlock the door.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
• Take care when cleaning the rear of the
appliance. Sharp edges can cut.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount of
ice and condensation.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
Replacing the Interior Lamp
WARNING: Allow the lamp to cool
before replacing. The lamp remains hot
immediately after use.
1. Turn Off and disconnect the appliance from the
mains power supply.
2. Unscrew the plastic lamp cover.
3. Remove the lamp by twisting it from the lamp
sockets.
4. Insert the new lamp and replace the cover.
2022/11/25 11:49 2022/11/25 11:49