Herunterladen Inhalt Inhalt Diese Seite drucken

Pack Contents; Installation - Polar UA001 Bedienungsanleitung

Kühlschrank/gefrierschrank
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
UK
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.

Pack Contents

The following is included:
POLAR Refrigerator / Freezer
Keys
Shelves
Shelf support bars
Top hinge and Bottom hinge (for UA001/UA002
only)
Instruction Manual
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.

Installation

Note: If the appliance has
been stored or moved in a
non-vertical position, stand
it in an upright position for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position.
4
UA001-UA002-UA003-UA004_ML_A5_v2_20211111.indb 4
UA001-UA002-UA003-UA004_ML_A5_v2_20211111.indb 4
Fitting the shelf support bars
Place the support bar on the ladder at the
desired height. For installation, the closed end
shall be located at rear and open end at front.
1. Push the support bar backwards to let its rear
end hang on the rear ladder (Step 1).
2. Lift the front end slightly then buckle it onto
the front ladder (Step 2).
Ladder
Support bar
Repeat for the remaining support bars.
Slide the GN pans/shelves into place.
Reversing the door (for UA001/
UA002 only)
The door handle is on the left side by default.
If necessary to reverse the door, follow below
operations:
Caution: All the operations
under this section should be
carried out only by trained
personnel or professional
technicians.
1. Turn the fixing locks as arrowed to release the
control panel.
2021/11/15 10:19
2021/11/15 10:19

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ua002Ua003Ua004

Inhaltsverzeichnis