Fakir AURA CLEAN Benutzerhandbuch Seite 35

Installing the microfiber mop pad
The steam cleaner shall never be operated without the mop pad attached.
Determine the part that shall stay on top, and put the mop on the pad and then place the
appliance on the pad.
To remove the pad, press your foot on the protruding part of the fabric and lift the appliance.
Installing the carpet glider
A carpet glider may be used to clean carpets and rugs with the appliance. Install the
microfiber mop pad before installing the carpet glider. Then install the carpet glider to use
the pad more comfortably on the carpet. To install the carpet glider, lift the appliance over
the attachment and attach the floor apparatus to the plastic head. Make sure that the head
is secured in place.
To remove the carpet glider, press your foot the protruding part of the plastic and lift the
appliance.
Filling the Water Tank
NOTE!
Unplug the steam cleaner before filling the water reservoir.
Do not touch any hot parts before allowing them to cool down adequately.
1. Lay the steam cleaner horizontally.
2. Open the cover of the water reservoir.
3. Fill the container provided with the appliance with water. Take care not to spill the water out.
Note : We recommend you to use purified water in steam cleaner particularly in areas where
hard water is available. You may use tap water in the appliance, but the use of untreated hard
water may reduce the performance of the appliance and shorten its service life. Never use
boiling water in your steam cleaner. Avoid using hard water.
4. Use the provided container to fill the reservoir up to the "MAX" line.
5. Close the lid of the reservoir and secure it. Lift the device upright.
The reservoir shall provide approximately 15 minutes of steam when it is filled. The appliance
shall not generate steam unless you turn on the power button and allow enough time for the
water to warm up.
NOTE!
The tube that transfers the water from the Water Reservoir to the heater is weighted with a
brass ball. This is an intentional design to increase the efficiency of water consumption. It
is normal for this ball to make a clicking sound inside the Water Reservoir during operation.
If you think the brass ball is loose from the tube, refer to the instructions provided in the
Troubleshooting Guide to secure it again.
35
EN