Operation - Makita DVP181 Bedienungsanleitung

To remove the battery cartridge, slide it from the pump
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place with
a little click. If you can see the red indicator on the upper
side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may accidentally fall out of the pump, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is not
being inserted correctly.
Battery protection system
The pump or battery is equipped with a battery protection
system. This system automatically cuts off power to the
motor to extend battery life.
The pump will automatically stop during operation if the
pump and/or battery are placed under one of the following
conditions:
Overloaded:
The pump or battery is operated in a manner that causes
it to draw an abnormally high current.
In this situation, turn the pump off and stop the application
that caused the pump to become overloaded. Then turn
the pump on to restart.
If the pump does not start, the battery is overheated.
In this situation, let the battery cool before turning the
pump on again.
Low battery voltage:
The remaining battery capacity is too low and the pump
will not operate. In this situation, remove and recharge
the battery.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.3:
1. Indicator lamps
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator lamps
Lighted Off
2. Check button
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first(far left) indicator lamp will brink when
the battery protection system works.

OPERATION

The pump does not contain oil when newly purchased.
Refer to "Adding oil" and add oil.
WARNING:
condition without oil added will damage the pump.
In addition, the oil tank will become hot and may result
in burns or other accidents.
Adding oil
► Fig.4:
1. Oil fill/Exhaust cap
2. Level line
1. Remove the oil fill/exhaust cap and add the supplied
oil via the filler port.
NOTICE:
Always use Makita genuine oil in order to
maintain pump performance.
2. Add oil until the oil level is between the upper and
lower level lines of the sight glass.
NOTICE:
The oil level is important. Operating the
pump in the condition with the oil level not between the
upper and lower level lines may result in malfunction.
Checking performance
► Fig.5:
1. Charging hose
(yellow)
2. Intake port
3. Vacuum pump
1. Connect the low side valve of the manifold and the
intake port of the pump with a charging hose.
2. Close the low side valve of the manifold.
3. Turn the pump on. If the pressure of the manifold
indicates a vacuum of -0.09 to -0.1 MPa within
30 seconds, the pump is operating properly.
4. Turn the pump off.
8 ENGLISH
Remaining
Blinking
The battery
may have
malfunctioned.
Operating the pump
3. Sight glass
4. Oil tank
4. Manifold
5. Low side valve
6. Close
capacity
in the