Hilti SF 4-A22 Original Bedienungsanleitung Seite 38

▶ Never transport batteries loose and unprotected.
batteries should be protected from excessive shock and vibration and
isolated from any conductive materials or other batteries that may come
in contact with the terminals and cause a short circuit. Comply with the
locally applicable regulations for transporting batteries.
▶ Do not send batteries through the mail.
instructions on how to ship undamaged batteries.
▶ Prior to each use and before and after prolonged transport, check the
product and the batteries for damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with
the temperature limits stated in the technical data.
▶ Do not store batteries on the charger. Always remove the battery from
the charger when the charging operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind
glass.
▶ Store the product and batteries where they cannot be accessed by
children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault
The power tool does
not work.
The control switch
cannot be pressed,
or is stuck.
The battery runs
down more quickly
than usual.
32 English
Possible cause
The battery is not fully
inserted.
Battery is discharged.
The forward/reverse
switch is in the middle
position.
Very low ambient tem-
perature.
During transport,
Consult your shipper for
Action to be taken
▶ Push the battery in
until it engages with
an audible click.
▶ Change the battery
and charge the empty
battery.
▶ Push the
forward/reverse
switch to the left or
right.
▶ Allow the battery to
warm up slowly to
room temperature.
2253604
*2253604*