Stadler Form Anton Gebrauchsanweisung Seite 12

place the tank in the unit. important: Please do not move the Anton when
it is filled with water. the water could splash out of the interior tank and
into the electronics.
3. next, turn on the Anton by pressing the on / off button (13). Afterwards,
the white light on the front of the unit will turn on, as will the lighting on
the water level indicator (10).
4. By turning the variable output controller (15), you can adjust the humidifier
output as you wish.
5. if you are bothered by the brightness of the small lights (i.e. in the bed-
room), you can reduce the brightness by pushing the night mode button
(14). you can choose between three different modes:
normal mode (default mode)
dimmed mode (push once)
Lights-out mode (push twice)
By pushing the dimmer button once more, you can go back into normal
mode.
6. you can also use the Anton to fragrance the room. we ask that you be
sparing when dealing with fragrances as too much can lead to malfunc-
tions and damage to the unit. to use fragrances, remove the water tank
(2) from the unit and trickle the fragrance directly into the water (see page
4). Add a maximum of 1-2 drops of fragrance per full tank of water. install
the water tank back into the unit.
Tip: would you like to change the fragrance? remove the water tank from
the unit, pour the remaining water out and clean the humidifier (see the
Cleaning section). now the Anton is ready to dissipate a different fra-
grance of your choice around the room.
7. when the water level indicator light changes from white to red, then the
water must be refilled. remove the water tank (2) and fill it up with tap
water. As soon as you put the tank back in the Anton, it continues normal
operation.
8. would you like to refill the water during operation? you can simply remove
the water tank and fill it up. the unit will operate for around a further 5
to 12 minutes with the water that remains in the system. Put the water
tank back into the unit within this time period and the Anton can continue
operation without stopping at all.
Note: Should you seen droplets (or other signs of dampness) on or
around the nut, then there is condensed water coming from the hu-
midifier. This means that the air can no longer absorb the moisture
from the humidifier. Please turn the output down so that droplets
are no longer visible.
Cleaning
Before each piece of maintenance and after every use, turn off the unit and
remove the plug from the plug socket. Before you clean the Anton, the pow-
er adapter (16) must be separated from the power adapter connection (17).
Attention: never submerge the unit in water (danger of short circuiting).
• to clean the outside, wipe with a damp cloth and then dry well.
• to clean the inside, remove the water tank (2), the fog outlet (1), the fog
chamber (5) and the ionic silver cube (8). then you can clean the ultrasonic
12