Auto Search; Web Configuration - Velleman CAMIP6 Bedienungsanleitung

7.2 Auto Search

• In order to use Auto Search, a camera must be connected to the same LAN (Local Area Network)
as the computer. Double-click on the Auto Search directory or right-click on Auto Search and
left-click again on Auto search to start searching the network.
Note: be aware that routers or firewalls might prevent the software from seeing the IP-camera. Get
advice from a network administrator when this is the case.
• The software interrogates the local LAN and shows all the found IP-camera IDs (e.g. 001015072)
under the Auto Search directory. Scroll the mouse over the camera ID to see the IP-address.
Note: a camera which is shown under the Auto Search directory is not available worldwide. It must
be moved to the Camera List (see § 7.4) to become accessible from another network.

7.3 Web configuration

• Right-click on the camera ID and left-click on Web configure to configure the camera using a
web browser.
Note: when configured in the appropriate way, the IP-camera can be reached from any
computer/web browser in the world. Simply type the IP-address into the address bar of the
web browser and enter the user name and password.
• The browser requires a username and password to set-up the camera. The default user name is
admin, no password required.
• When user name and password are validated, the information page is shown.
15/09/2010
All manuals and user guides at all-guides.com
CAMIP6
7 ©Velleman nv