Battery Charge Indicator; Working Advice; Dust/Chip Extraction - Bosch Keo Originalbetriebsanleitung

14 | English

Battery charge indicator

The battery charge indicator (5) indicates the remaining bat-
tery capacity or an overload when the power tool is switched
on.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Slow flashing 1 x green
Operation
Switching on and off (see figure G)
Firstly, press the lock-off button (7) and then the On/Off
switch(6). You can release the lock-off button (7) when the
power tool is running. The lock-off button (7) engages again
as soon as the power tool comes to a complete stop.

Working Advice

Always follow the safety advice provided.
u
Troubleshooting
Sabre saw
Problem Possible Cause
Power tool fails to op- Battery discharged
erate
Power tool defective
Internal wiring of garden tool defective
Power tool functions On/Off switch defective
intermittently
Excessive vibrations/ Power tool defective
noise
Sawing time per bat- Blade holder area needs cleaning
tery charge too low
Saw blade worn
Poor sawing technique
Battery not fully charged
The saw blade is run- Battery is getting discharged
ning slow
Overloaded during operation
F 016 L94 166 | (11.10.2021)
Selecting the saw blade
Use only saw blades suitable for the material being worked.
An overview of recommended saw blades can be found at
the end of these operating instructions. Do not use other
blades than recommended.
Capacity
Use a narrow saw blade when sawing tight curves.
≥ 75 %
40 − 75 %

Dust/Chip Extraction

15 − 40 %
Dust from materials such as lead-containing coatings, some
0 − 15 % wood types, minerals and metal can be harmful to one's
health. Touching or breathing-in the dust can cause allergic
reactions and/or lead to respiratory infections of the user or
bystanders.
Certain dust, such as oak or beech dust, is considered carci-
nogenic, especially in connection with wood-treatment ad-
ditives (chromate, wood preservative). Materials containing
asbestos may only be worked by specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the ma-
terials to be worked.
Avoid dust accumulation at the workplace. Dust can
u
easily ignite.
Corrective Measure
Recharge battery; also see "Battery Charging"
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Hold the tool to point to the ground and start to
operate
Change saw blade
see "Working Advice"
Recharge battery; also see "Battery Charging"
Recharge battery; also see "Battery Charging"
Reduce pressing force of tool against branch
Bosch Power Tools