Vacuum Cleaner Preparation; Fixing Vacuum Cleaner Into Adapter; Fixing Acessories; Battery Charging - Fakir INOVAX Benutzerhandbuch

EN

Vacuum Cleaner Preparation

Remove all packing material, take out the vacuum cleaner and the accessories. Remove all
possible adhesion foils, stick-on labels or paper from the appliance.
Vacuum Cleaner Assembly
When assembling the vacuum cleaner, follow the procedure indicated in Fig. 1, 2.
For disassembly, proceed the other way round and release the locks.

Fixing Vacuum Cleaner Into Adapter

Put vacuum cleaner A to adapter E with the suction vent and they tilt the vacuum cleaner to
the aperture to the maximum position (you will hear a snapping sound), (Fig. 2).
After taking the vacuum cleaner from the adapter you have to push lock button A3 and then
to pull the vacuum cleaner out.

Fixing Acessories

When connecting and disconnecting the accessories, follow the procedure in Fig. 3, 4.
Slide the selected adapter to the hole in dust container B to the maximum position. Remove
the adapter in the opposite direction.

Battery Charging

Turn the vacuum cleaner off prior to charging!
According to Fig. 2, place the vacuum cleaner on the charging stand H. Before the first
use, the battery has to be charged for at least 12 hours. Connect the stand to mains, using
adapter I. The battery charging is indicated by the light indicator A2. The battery becomes
fully charged after approximately
5 to 6 hours of charging, allowing up to 45 minutes of operation. The appliance is fitted with
an automatic battery overcharge protection (after the maximum charge level is achieved, the
charging will switch off).
Red flashing
Lit in red
Lit in green
Operation signal lights and charging lights (A2)
Discharged battery.
Accumulator is charging.
Accumulator is charged / indication of operation.
38