COMEM eSDB10 Bedienungsanleitung Seite 7

A
WARNING
B
Between the plug and the housing must be positioned an or
gasket to avoid any leakage.
The system (pipe and plug) must be assembled to guarantee
the sealing.
eSDB-15/30/40
First step: Remove the tape/plastic cap from the entry/
C
exit air zones. Fix the upper flange (Fig.10/A) on the flange
of the pipe from the conservator
(Fig.10/B) with tour M12 screws (Fig.10/C).
CAUTION
5
D
Put the plane gasket between the two flanges.
B
E
A
F
Figure 10
Second step: Check the upper level (Fig.16/17/18/19/E),
1
the internal bubble must be inside the smallest black ring.
Third step: unscrew the bottom screw in the lower part of
the device (Fig.11/A) until the end of the screws working
range.
Figure 11
CREATED BY
Diego Boro
APPROVED ON
-
COMPANY TITLE / SUPPLEMENTARY TITLE
COMEM ESDB10
COMEM
The transformer manufacturer can choose whether to apply the
-
RESPONSIBLE DEPARTMENT
ITABB-9AAE306693
anti-vibration kit which is supplied with the eSDB depending on the
DOCUMENT ID
sturdiness of the support (fig.12/A). For the electrical connections
COMEM advises to use armed cables.
5
1
A
B
C
6 7
D
E
F
1
2 3
A
REVIEWED BY
NOTE
-
DOCUMENT KIND
Component Drawing
NE-1188
© COPYRIGHT ALL RIGHTS RESERVED
6 7
2 3
8
Figure 12
A
C
B
2 3
C
4
D
E
APPROVED BY
-
BASED ON DOC ID WORK ORDER ID PROJECT ID
F
STATUS REV ITER SHEET
A
Development
2 1/1
8
DRAWING SHEET ISO 5457: 1999-A3T
4 5
A
CREATED BY
Diego Boro
APPROVED ON
-
COMPANY
COMEM
CREATED BY RESPONSIBLE DEPARTMENT
ITABB-9AAE306693
Diego Boro
APPROVED ON
-
4 5
COMPANY TITLE / SUPPLEMENTARY TITLE
COMEM ESDB10
COMEM
-
RESPONSIBLE DEPARTMENT
ITABB-9AAE306693
DOCUMENT ID
5
6
REVIEWED BY
-
DOCUMENT KIND
Component Drawing
TITLE / SUPPLEMENTARY TITLE
COMEM ESDB10
REVIEWED BY -
-
DOCUMENT ID
NE-1188
DOCUMENT KIND
Component Drawing
© COPYRIGHT ALL RIGHTS RESER
6
NE-1188
© COPYRIGHT ALL RIGHTS RESERVED
6 7
7
7
APPROVED BY
-
BASED ON DOC
7
STATUS
Develop
DRA