Getting Started - Alpine X800D Kurzanleitung

Getting Started

Touch operation
You can operate the system by using the touch panel on the screen.
e
Common onscreen buttons
: Returns to the previous screen. Depending on the function, this button may cancel the operations
performed on the screen.
: Closes the window.
Location of Controls
• This is only an example illustration, about the name and layout of
buttons, please refer to your vehicle.
A
RESET switch
The system of this unit is reset.
B
(My Favourites) button
The My Favourites screen for registered User1 or User2 is displayed.
C
Microphone
Used for Hands-Free or Voice Control modes.
D
AUDIO button
Displays the Audio/Visual screen. If the Audio/Visual screen is
already displayed, changes the source. Press and hold this button for
at least 3 seconds to activate the "Easy Sound Setup" mode.
E
+ / – (DOWN/UP) button
Press to adjust the volume.
F
button
Press to activate/deactivate the mute mode. Press and
hold this button for at least 3 seconds to turn the power off.
G
CAM (Camera) button
Press to display rear camera image.
Press again to return to normal screen.
Turning Power On or Off
1
Turn the ignition key to the ACC or ON position.
The system is turned on.
2
Press and hold the
Owner's manual
button for at least 3 seconds to turn the power off.
Touch operation, Location of Controls, Turning Power On or Off
a / d button
H
Press to seek down/up station in radio
mode or down/up track, chapter, etc., in
other audio/visual source.
I
NAV button
Recalls the navigation map screen.
Press again to switch to Navigation menu
screen.
Press and hold this button for at least 3
seconds to change to Go Home route
screen. If the Home is not set yet, it will
change to Home setting screen.
J
(Phone) button
Recalls the Telephone Menu screen.
When a hands-free phone with Voice
Recognition is connected, press and hold
for at least 3 seconds to recall the Voice
Recognition mode.
c (Eject) button
K
Recalls the Open/Tilt screen.
If the disc does not eject after touching [c]
of DISC, press and hold this button for at
least 5 seconds.
L
Remote Sensor
Point the remote control transmitter
towards the remote sensor within a range
of 2 metres.
3
-EN