Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-R481 Bedienungsanleitung

GETTING STARTED

1

Cancel the demonstration

When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" "PRESS ENTER"
1
Press .
[YES] is selected for the initial setup.
2
Press again.
"DEMO OFF" appears.
2

Set the clock and date

1 Press and hold .
2 Press to select [CLOCK], then press
To adjust the clock
3
Press to select [CLOCK ADJUST], then press
4
Press to make the settings, then press
Hour Minute
5
Press to select [CLOCK FORMAT], then press
6
Press to select [12H] or [24H], then press
To set the date
7
Press to select [DATE SET], then press
8
Press to make the settings, then press
Day Month Year
9
Press to exit.
To return to the previous setting item, press
4
ENGLISH
3

Set the basic settings

1
Press and hold
2
Press
3
Repeat step
4
Press
To return to the previous setting item, press
SYSTEM
KEY BEEP
SOURCE SELECT
AM SRC *
BUILT-IN AUX * ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
.
F/W UP xxxx
.
CLOCK
.
TIME SYNC
.
.
CLOCK DISPLAY ON: The clock time is shown on the display even when the unit is turned off. ;
ENGLISH
.
.
РУССКИЙ
ESPANOL
. * Not displayed when the corresponding source is selected.
.
to select an item (see the following table), then press
.
2
until the desired item is selected or activated.
to exit.
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables. ( 7)
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: <http://www.jvc.net/cs/car/>.
ON: The clock time is automatically set using the Clock Time (CT) data in FM
Radio Data System signal. ; OFF: Cancels.
OFF: Cancels.
Select the display language for menu and music information if applicable.
By default, ENGLISH is selected.
.
Default: XX