Installation; Installing Adapters On The Hose Ends; Connecting The Lines/Pipes - Steinbach MINI Bedienungsanleitung

2. Lay the hoses from the water treatment system to the setup location of the heat pump (see Fig. F).
Make sure that there is no tension on any of the lines routed to the heat pump and that they are not
in the way.
3. Lay the supply line for the heat pump's power supply (see section "Technical data").
Use an extension cable or a socket with the required protection class for the environmental
conditions of the connection site!
The setup location is prepared.

Installation

Installing adapters on the hose ends

1
2
The heat pump is always the last link in the water treatment system. If a filter or salt
system or similar is used, it must be connected upstream of the heat pump so that the
filtered, treated water flows through the heat pump.
1. Clean large-particle soiling from the connection points of the heat pump
the hose ends of the water pipes.
2. Screw an adapter
2
3. Screw an adapter
2
4. Attach the hose end of the drain line with a hose clamp
connection (see Fig. 1).
6
5. Connect the hose end of the feed line with a hose clamp
connection (see Fig. 1).
7
The adapters are installed on the hose ends.

Connecting the lines/pipes

Establishing the power supply
The MINI heat pump cannot be operated with an external timer and you need to manually switch the
pump on and off via the RCD power plug.
1. Connect the RCD power plug
The power supply is established.
Connecting a drain pipe for condensation water (optional)
1. Insert the drain connection piece
2. Attach the drain pipe (garden hose) for condensation water to the drain connection piece
The drain pipe for condensation water is connected.
34
3
onto the outlet water connection
onto the inlet water connection
to the power supply prepared at the setup location.
C
into the hole in the base plate.
4
, the adapters
1
.
6
.
7
and the adapter on the outlet water
3 2
and the adapter
3 2
and
2
on the inlet water
.
4