eta Fenité Sonic Clean Bedienungsanleitung Seite 19

C – USB cable *
* USB cable: A source with USB terminal may be connected to USB cable (for
example AC power adapter, backup power source, etc.).
III. INSTRUCTIONS FOR USE
Before using the appliance, its battery must be charged first. Charging is
possible with the enclosed USB cable from the mains, i.e. an AC adapter,
or a backup power source. While charging, the appliance cannot be used (with
the connected cable).
CHARGING
– Before the first use or if the appliance was not used for a long time, charge it
completely.
– The standard charging time is approximately 2 hours. and the fully
charged accumulator allows for the operating time of up to 60 minutes. The
operating time decreases depending on the appliance loading and due to the
accumulator ageing and wear and tear.
1. Make sure the appliance is switched off.
2. Connect the enclosed USB cable to the power supply terminal, and connect
the other side to a power source, for example to a compatible AC power
adapter, or to a backup power source. While charging, the appliance cannot
be in use. If the appliance is turned on and you start charging, the appliance
shall switch off.
3. Do not exceed the designated charging time!
Red flashing
Permanent red lighting
Optimise the battery service life
– Do not leave USB cable connected to the appliance.
– During charging or regular operation, the appliance heats up, which is
a normal phenomenon, and not a reason for a complaint.
CONTROL
– By long pushing of button A1 (approx. for 2 seconds) you switch the appliance
on/off. Upon switching on and off an acoustic signal sounds.
– After short pushing of button A1 you may switch between 2 modes (
An acoustic signal sounds with every mode switching and the light control of
the particular mode lights up (BLUE).
– By short pushing of button A2 you may set the intensity. The set intensity
level is signalled by light control A4 (ORANGE - low intensity; GREEN - high
intensity). The intensity may be set for both modes (
signal sounds with every switching.
USE
With use of acoustic vibrations (frequency of 24 000 Hz) the appliance
thoroughly cleans the skin and removes dead skin cells. It also improves
absorption of various cosmetic preparations and softens the skin.
Skin cleansing mode "
1. Moisten your face skin.
2. Switch on the appliance and set the skin cleansing mode "
you may also set the intensity level.
3. Place the stainless-steel part of the head (B1/B2) to the face skin using
a slight pressure and move it evenly over the entire face skin, as shown
on fig. 2.
4. After the work termination, switch the appliance off and wash your face with
water.
Charging light signal (A5)
Indication of charging in progress
Indication of a fully charged accumulator
(an acoustic signal sounds)
" (Fig. 2)
19 / 39
EN
/
/ ) and an acoustic
". If needed,
).