AIRLUX AHK128IX Bedienungsanleitung Seite 8

EN
GENERAL INSTRUCTIONS
Carefully read the following important information
regarding installation safety and maintenance.
Keep this information booklet accessible for further
consultations.The appliance can be installed
in either the EXAUST (external air exhaust) or
RECIRCULATING (internal air recycle) mode.
USE INSTRUCTIONS
CONTROL PANEL
TYPE C A
(Fig. )
- Light ON/OFF
- Reduce fan speed (4 to 1)
- ON/OFF.
Switch on the cooker hood at speed 1.
Switch off the cooker hood at any speed.
- Increase fan speed (1 to 4)
- TIMER - Activate the timer function.
The timer will automatically switch off the fan
after 15 minutes. When the fan speed is set to
4
the timer activates automatically.
TIMER AUTO
When the suction speed is set to 4
The timer is automatically activated for 7 minutes
Then passing to speed 3
SAFETY INSTRUCTIONS
In certain circumstances electrical appliances
may be a danger hazard.
• The hood has been designed to remove the kitchen
smells; any other additional use shall be regarded
as non-intended.
• Areate the room if other appliances that are not
supplied by electrical power are being used while
the hood is on.
• Do not leave the cooker on if it is not being used.
• Do not flambé food directly under the cooker hood to
prevent the grease filter catching fire due to flames.
• Constantly check food frying to avoid that the
overheated oil may become a fire hazard.
• Do not check the status of the filters while the cooker
hood is operating.
• Do not touch the light bulbs after appliance use.
USE AND MAINTENANCE
It is recommended to switch on the appliance
before cooking. It is also recommended to leave
the appliance in operation for 10 minutes after
cooking is terminated in order to completely
eliminate cooking
The proper function of the cooker hood is
conditioned by the regularity of the maintenance
operations, in particular, the active carbon filter.
Clean the fan and other surfaces of the cooker hood
regularly using a cloth moistened with denatured
alcohol or non abrasive liquid detergent.
WARNING: unplug the appliance or switch
off the circuit breaker before carrying out
maintenance operations.
METALLIC ANTI-GREASE FILTERS
- The filters must be washed at least once a month
with hot water and household detergent.
8
vapours and odours.
- They can also be washed in the dishwasher.
- To disassemble unscrew the fixing screw in the
middle of the filter. (Fig. 1)
ACTIVATED CARBON FILTER (Fig. 2)
(Only filtering types) sold aside
- The filter cannot be regenerated, it must be re-
placed at least once every two months.
- For the substitution it is necessary to remove the
central anti-grease metal filter, slide out the modu-
lar filter from its housing situated inside the cooker
hood.
LIGHTING
In order to change the mounted lamps:
- rotate the light unit anti-clockwise;
- remove the light unit (Fig. 3).
- Replace the lamp with one that has the same fea-
tures because one with major power may cause
severe damage to the electrical system.
INSTALLING INSTRUCTIONS
GENERAL INFORMATION
This hood has been arranged to be installed above
a cooktop. It can be used in 2 ways:
• EXAUST MODE: the kitcken vapours are purified
by the metal anti-grease filters and carried outside
through a ducting system.
• RECIRCULATING MODE: the kitcken vapours
are purified by the metal anti-grease filters and an
activated carbon filter, then conveyed back into the
kitchen.
We suggest to have installation carried out
by qualified personnel, in compliance with
all the current regulations and in particular
with the ones concerning air exhaust and
electrical connection.The manufacturer cannot
be held liable for damages caused by improper
installation or if it has not been carried out
according to the state-of-the-art.
COMPONENTS (Fig.
A - Complete hood casing
B - Closing panel anchorage bracket
C - Rear closing panel
D - Box support bracket for wall
E - Reduction fitting dia. 120/150
F - Deflector (only for filtering types)
G - Upper stack wall clamp
(only for aspirating types)
H - Upper telescopic stack
I - Lower telescopic stack
L - Bag with accessories and screws
INSTALLATION
The appliance must be installed at a minimum
height of 650 mm from an electric cooker stove, or
750 mm from gas or combined cooker stoves.
If a connection tube composed of two parts is used,
the upper part must be placed outside the lower
part. Do not connect the cooker hood exhaust to
D
)
EN