Hama 179779 Bedienungsanleitung Seite 13

Note: Energy saving function
• The remote control switches itself off automatically if a button is pressed
for longer than 15 seconds. This prolongs the life of the batteries if
the remote control is stuck in a place where the buttons are pressed
permanently, e.g. between sofa cushions.
5.Setup
Note
• For proper infra-red transmission, always hold the remote control in the
approximate direction of the device to be operated.
• Press the "MODE" button to select the secondary device group: AUX,
AMP,DVB-T, CBL (8 in 1 model only).
• Press the "SHIFT" key to control the blue function keys. The shift function
is deactivated by pressing the "SHIFT" key again or automatically after 30
seconds if no key is pressed.
• If no entry is made within 30 seconds, SETUP mode is automatically
terminated. The LED flashes six times and then goes out.
• Each type of device can be programmed under any device key, e.g. a TV
can be programmed under DVD, AUX, etc.
• You cannot operate a device with the universal remote control while it
is in Setup mode. Exit Setup mode and select the device to be operated
using the device selection buttons.
• Please note that the remote control emits infra-red signals. These are not
visible to the human eye.
5.1 Direct code entry
A code list is included in the universal remote control's extent of delivery. The
code list contains four-digit codes for setting the remote control to work with
most AV equipment manufacturers.
For easy orientation, the codes are sorted first by type of device (TV, DVD, etc.)
and within the type of device alphabetically by brand name.
5.1.1 Switch the device you wish to operate on.
5.1.2 Press the "SETUP" button until the LED lights up continuously.
5.1.3 Use the device button to select the device to be operated (e.g. TV). If
the selection is successful, the LED flashes once and then lights up
permanently.
5.1.4 Search the code list for the brand and type of the device to be operated.
5.1.5 Enter the corresponding four-digit code using the number keys 0-9. The
LED confirms the entry of each digit with a short flash and goes out
after the fourth digit.
5.1.6 Then test the remote control and check whether the desired functions
can be controlled. It is possible that the first code is not the most
suitable, and possibly not all functions are available. In this case, try the
next code mentioned for the selected device type/brand from the list.
Note
• A valid code is automatically saved.
• If the code is invalid, the LED flashes six times and then goes out. Repeat
steps 5.1.1 to 5.1.5, or use another method to enter the code.
11